top of page

ARRI

Public·2 members

Venice 2 + Arri setup


Hello Community Fam!


Next week I’m going to be shooting with Venice 2 and I’d like some opinions about this camera setup that I think, ideally, would work.



Cforce RF motor (focus): Connected to front Lens port via CAM / Hirose (12pin) for Metadata - Lbus/Lbus to Cforce Mini Motor (Iris) - Lbus/Lbus to RIA-1 and finally from RIA-1 CAM to Dtap/Hirose (8pin) to Remote back port for Tally & Run/Stop.


For IRIS and Long range control: RIA-1 will be in Host mode with RF 2400 (orange module) connected to an SX hand unit also with RF 2400 (orange module)


For FOCUS control: Cforce RF motor also in Host mode (different channel from RIA-1) connected to Hi5 hand unit with RF-EMIP.  Both hand units with Sony Camera Control License.


CineRT connected to RIA-1 via Serial connector



I’d like to know if this would work or could be some interference/malfunction of any kind due the RF motor and RIA-1 are both in Host mode. Does anybody recommends, add or change anything else?


Thanks to all!


Joe

103 Views
Joe Burgos
Joe Burgos
Oct 14

Thanks!!

Members

bottom of page