DTAP Micro Voltmeter - Stay on top of your power!

www.thingiverse.com

A smart voltmeter housing that lets you monitor your camera or monitor's voltage at a glance. Printed in nylon and tested in PLA (PETG would probably also be good). All you need is a 0.28" micro voltmeter, a bit of wire and a connector of your choosing (I use DTAP). The cable used is Van Damme 2 strand installation wire. The through hole lets you mount the device anywhere in any orientation with a 1/4 20" screw

A smart voltmeter housing that lets you monitor your camera or monitor's voltage at a glance.

Printed in nylon and tested in PLA. All you need is a 0.28" micro voltmeter, a bit of wire and a connector of your choosing (I use DTAP). The cable used is Van Damme 2 strand installation wire.

The through hole lets you mount the device anywhere in any orientation with a 1/4 20" screw

This is especially useful with cameras like the Sony FX9 with an external V-lock battery, as the camera has no idea how much power it actually has, and wont shut off until the battery shuts down.