Rf Motor + LCS cable + Plus Body 
 arri 
 By James Teninty 

 on 2/21/19, 7:19 PM • 547 views
Running the WCU-4 with RF on the 416 Plus through D-Tap works seamlessly. When trying to power through the LCS cable, the hand unit receives the voltage and film count (which is nice), but I lose the ability to control the motors...


is there a way way to run this set up and have everything... camera data plus control? 


Thanks



 Clemens Hönig 

 On 2/21/19, 7:37 PM
I guess throug the EXT cable there is not enough power provided to run the motor. I would recommend to power the motor through the LBUS port to Ptap, while the CAM port is connected to the EXT on the camera.
 

 Borek 

 On 3/21/19, 1:31 PM
This should be something for the RS cable. With this you should be able to power and start/stop.

 
Yes, absolutely right. Not sure about Data though...
 Convert as an answer Clemens Hönig 

 on 3/21/19, 1:34 PM


